8:41:00 PM
world of Explore new
Most of the power supply failure indicator
circuits need a separate power supply for themselves. But the alarm
circuit presented here needs no additional supply source. It employs
an electrolytic capacitor to store adequate charge, to feed power
to the alarm circuit which sounds an alarm for a reasonable duration
when the supply fails.
This circuit can be used as an alarm for power supplies in the range of 5V to 15V.
To calibrate the circuit, first connect the power supply (5 to 15V) then vary the potentiometer VR1 until the buzzer goes from on to off.
Whenever the supply fails, resistor R2 pulls the base of transistor low and saturates it, turning the buzzer ON
This circuit can be used as an alarm for power supplies in the range of 5V to 15V.
To calibrate the circuit, first connect the power supply (5 to 15V) then vary the potentiometer VR1 until the buzzer goes from on to off.
Whenever the supply fails, resistor R2 pulls the base of transistor low and saturates it, turning the buzzer ON
